Atgames legends pinball mods8/19/2023 ![]() After performing the above, set the Haptic Strength (global) to High.Cut out a small “U”-shaped piece of foam and apply it below the bottom plastic skirt of the Joystick.Apply a strip of AC foam along the front apron of the ALP (metal bar).Re-install the two screws for the Arcade Control Panel.Doing this may also cause bending/warping of the control deck. Apply a strip of AC foam around the entire perimeter of the deck (top/bottom and left/right sides).A nail file was used to push the AC foam insulation around the trackball. Use extreme caution here as the force may crack the the plastic on the deck. ![]() ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |